JFBL Hot DDS frequency signal generator sine wave square wave Trilateral sawtooth electronic measuring instrument

15.01

Product ID: 26244 SKU: 32850556567 Category:

JFBL Mini ammeter digital ammeter led Panel meter 0-50 LED redUSD 2.83/piece

JFBL Hot New LCR-T7 TFT Transistor Tester Diode Triode Capacitance ESR Meter LCR MOSFETUSD 18.89/piece

JFBL Hot 15cmx3cm Rainbow Optical Glass Triple Triangular Prism Physics Teaching Light Spectrum with Gift BoxUSD 6.28/piece

JFBL Hot LCR-TC1 3.5inch Colorful Display Multifunctional TFT Backlight Transistor TesterUSD 16.95/piece

JFBL Hot-Round 0-180 psi 13mm 1/4BSP Diameter Dial Comparator Air Manometer, BlackUSD 2.02/piece

JFBL Hot DDS frequency signal generator sine wave square wave Trilateral sawtooth electronic measuring instrumentUSD 16.86/piece

Portable 5MP 50X-500X Magnification 8-LED USB Digital Microscope Endoscope with Stand for Industrial Biological InspectionUSD 12.36/piece

JFBL Hot Digital depth gauge caliper tread depth gauge LCD Tyre tread gaugeUSD 5.61/piece

Operating Voltage: DC9V
DDS frequency range: 1Hz-65534Hz
High-speed frequency(HS) output up to 8MHz
DDS signal amplitude of the offset amount can be adjusted separately by two potentiometers
DDS signal: Sine wave, Square wave, Sawtooth, Reverse sawtooth, Triangle-wave, the ECG wave and noise wave.
1602 LCD menu
Intuitive keyboard
Section into the value: 1, 10, 100, 1000, 10000Hz
The power automatically restore the last used configuration
Offset: 0.5Vpp-5Vpp
Amplitude amount: 0.5Vpp-14Vpp
Full-speed USB support using Windows standard drivers
Real-time execution
Processors run at maximum speeds
MPLAB IDE compatible (free copy included)
Built-in over-voltage/short circuit monitor
Firmware upgradeable from PC/web download
Totally enclosed
Supports low voltage to 5 volts (1.8v to 5.0v range)
Diagnostic LEDs (power, active, status)
Read/write program and data memory of microcontroller
Erase of all memory types (EEPROM, ID, configuration and program) with verification
Freeze-peripherals at breakpoint
Program up to 512K byte flash with the Programmer-to-Go
Basic Debugger System
The debugger system can be configured to use standard ICSP communication for both programming and debugging functions.
CAUTION: Do not change hardware connections while the PICkit3 or target is powered
Package Contents:1 x DDS signal generator
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.